Press the [ ] key after you have made your pager phone number changes. Pressing the [ ] key saves your new pager number. An acknowledgement tone sounds. To exit without saving changes, press the [ ] key to exit pager phone number programming. Turn your security system on. Early warning fire detection is best achieved by the installation of fire detection equipment in all rooms and areas of the household as follows: A smoke detector installed outside of each separate sleeping area, in the immediate vicinity of the bedrooms and on each additional story of the family living unit, including Page Emergency Evacuation Emergency Evacuation Establish and regularly practice a plan of escape in the event of fire.
The following steps are recommended by the National Fire Protection Association: 1. When lit, the system is running on primary power; when not lit, the system is running off the backup battery. This is determined at the time of installation. The intent is to advise you of the alarm or trouble and allow you to respond promptly. The FCC requires the following statement for your information: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception.
In the following table, enter a description of the area of protection for each zone. Example: Zone 1 Windows on North side of building. Zones 13 through 48 are not used with the OMNI Zones 25 through 48 are not used with the OMNI All keypads are equipped with emergency-pair keys.
In order to activate the alert, both keys must be pressed at the same time. The type of keypad you have installed dictates which keys you press. Your installer will show you how to activate these emergency keys.
The emergency keys used for all keypads are shown below. NOTE: These key combinations may also be programmed for other system functions. If programmed, a button on a designated keyfob may also be used to send an alert message to a pager. Ask your installer if this was done.
In the following table, enter the names of the individuals assigned to each user number. Turns off when the fire bell times out or is turned off. Page 92 Maintenance is best performed by your installing company with trained service personnel. On the front cover of this equipment is a label that contains, among other information, the FCC registration number and ringer equivalence number REN for this equipment.
If requested, this information must be provided to the telephone company. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. This manual is also suitable for: Omnieu. Table of Contents. Previous Page. Next Page. Check to make sure the system is ready. Enter your 4-digit or 6-digit user code. Page 4 Connects to downloader while on line, disconnects User On-line home phone.
You have chosen a reliable, state-of-the-art security system that is remarkably easy to operate. Your system has been professionally installed by your local Security Company whose representative can explain the specifics of your system. In order to activate the alert, both keys must be pressed at the same time. The type of keypad you have installed dictates which keys you press. Your installer will show you how to activate these emergency keys. You can arm and disarm the burglar portion of your security system.
The following conditions will be indicated by the zone lights LED keypad or described on the display: Fast Blink All interior protection is disarmed, so you are free to move around inside.
0コメント